Floor Mounted Eye Wash With Foot Pedal

Modern MD540N-SS316L Stainless Steel Floor Mounted Eye Wash with Foot Pedal Emergency eyewash and shower units are designed to rinse contaminants from the user's eyes, face or body. As such, these units are forms of first aid equipment to be used in the event of an accident. However, they are not a substitute for primary protective devices (including eye and face protection and protective clothing) or for safety procedures when handling hazardous materials. MD540N Stainless Steel Stand Eye Wash with Foot Pedal main material is SS 316L stainless steel, foot pedal is made of ABS, which is resistant to corrosion. Location In general, the ANSI standard requires that emergency equipment be installed within 10 seconds walking distance from the location of a hazard (approximately 55 feet). The equipment must be installed on the same level as the hazard (i.e. accessing the equipment should not require going up or down stairs or ramps). The path of travel from the hazard to the equipment should be free of obstructions and as direct as possible. The location of the emergency equipment must be marked with a highly visible sign. Original water Drinking water or filtered water (Potable Water). Hydraulic Pressure and flow Rate Recommended working pressure: 0.2-0.6MPA . Eye wash flow >= 11.4L / Min Eye Wash Nozzle: green ABS spray, others are 316L stainless steel with 10" waste water recycle bowl Training Simply installing emergency equipment is not sufficient means of ensuring worker safety. It is also very important that employees are trained in the location and proper use of emergency equipment. Research shows that after an incident has occurred, rinsing eyes within the first ten seconds is essential. Therefore, employees at the highest risk of damaging their eyes in each department must be trained regularly. All employees must know the location of the emergency equipment and be aware that quick and effective rinsing is important in an emergency. The sooner the injured employee's eyes are rinsed, the lower the risk of damage. Every second is important when preventing permanent damage to save time for medical treatment. All employees must be reminded that this equipment is only to be used in emergencies, tampering with the equipment may cause a malfunction. In emergencies, the afflicted may be unable to open their eyes. Employees may feel pain, anxiousness and loss. They may need others' help to reach the equipment and use it. Push the handle to spray the water. Put the injured employee's head over the eye wash bowl which is hand controlled. When rinsing the eyes, use both hands' thumb and index finger to open the eyelids, rinsing for at least 15 minutes. After rinsing, seek medical treatment immediately. HSE and supervisory personnel must be notified that the equipment has been used. Installation Steps Screw the eye wash bowl onto the main body. Connect the base to the floor. Connect the T-type drainage pipe to the base. Connect the main body to the T-type drainage pipe Screw the eye wash nozzle onto the main body Install the lever onto the main body valve. Connect the foot pedal to the base. Connect the chain to the foot pedal and lever. Attention Wrap every joint between pipes with PTFE tape Accessories & Components Chain Foot Pedal Instruction Sheet Warning Sign Base T-type Drainage Pipe Main Body Eye Wash Bowl Eye Wash Nozzle Lever